Skip to product information
1 of 5

Noseto

Oval Diamond Honing Rod 300mm

Oval Diamond Honing Rod 300mm

Regular price $60.00 AUD
Regular price Sale price $60.00 AUD
Sale Sold out
Taxes included.
Add Custom Engraving
Quantity

30cm Oval Diamond Honing Rod

A 30cm diamond rod with an oval cross-section, for keeping a working edge between proper sharpenings. Longer than most, so it clears a 240mm blade in a single pass.

What a diamond rod actually does

Worth being clear, because the word “honing” hides it. A traditional smooth steel does not sharpen. It pushes a rolled edge back into line, and once an edge is genuinely dull a steel does nothing for it. A diamond rod is different: the surface is embedded with industrial diamond, so it cuts metal away and creates new edge rather than straightening old edge.

That makes it far more useful and slightly less forgiving. A few light strokes bring a tired knife back to cutting properly. Heavy or careless strokes remove more steel than you intended.

Why oval

A round rod touches your edge along a single line, so you need more strokes and you tend to wear a groove in one part of the rod. The oval face puts several times more diamond in contact at once, which means fewer passes, more even contact across the edge, and a rod that wears flat rather than channelled. It is the reason professional kitchens moved away from round steels.

Why 30cm

Your rod should be longer than your blade. At 30cm this covers everything up to a 240mm chef knife or carving knife in one continuous stroke, which is how you keep the angle consistent. A 20cm rod and a 240mm blade means breaking the stroke halfway, and that is where people round their edges off.

What it suits

This rod is at its best on Western and softer stainless knives, which run around 56 HRC and roll rather than chip. For those, it is the single most useful thing you can own between sharpenings.

Be careful with hard Japanese knives at 60 HRC and above. A thin hard edge does not roll, it chips, and a diamond rod applied with any pressure will take micro-chips out of it. If your knife is a hardened Japanese blade, use a whetstone or bring it to us instead.

Specifications

Type Diamond honing rod
Rod length 300mm (11.8")
Cross-section Oval
Surface Diamond-coated

How to use it

Hold the rod tip-down on the bench or out in front of you, set the blade at roughly 15 to 20 degrees, and draw the edge from heel to tip in one smooth pass. Light pressure, the weight of the knife is close to enough. Three or four strokes a side is plenty, and if it is taking more than that the knife needs sharpening, not honing.

Diamond is an abrasive coating and it does deplete with use. Rinse and dry the rod after use and store it where it is not rubbing against other steel.

View full details