Passer aux informations produits
1 de 8

Noseto

Noseto Hada 180mm Bunka SK5 carbon steel and nickel, Honduran rosewood burl and horn

Noseto Hada 180mm Bunka SK5 carbon steel and nickel, Honduran rosewood burl and horn

Prix habituel $482.00 AUD
Prix habituel Prix promotionnel $482.00 AUD
Promotion Épuisé
Taxes incluses.
Add Custom Engraving
Quantité

Noseto SK5 Bunka 180mm

A bunka is a santoku with the tip put back. This one is made by hand, with a 52100 core clad in SK5 carbon steel and nickel, and a handle in Honduran rosewood burl and horn. 145g, which is light for 180mm.

Why a bunka

A santoku push cuts beautifully and cannot do anything fine, because it has no point. A gyuto has the point but a curved belly that lifts off the board. The bunka takes the flat edge of the santoku and finishes it with a reverse tanto tip: a straight angular point that sits low and gets into detail work, boning a quail, scoring skin, trimming, splitting a chilli. At 180mm it covers almost everything a home or small kitchen puts on the board, and it is the knife to buy if you want one blade that does both the bulk and the fine work.

The steel

The core is 52100, a high-carbon bearing steel with a famously fine grain. Fine grain is what lets an edge go truly keen rather than merely sharp, and it is why custom makers keep returning to 52100 when they could reach for something more fashionable.

The cladding is SK5 carbon steel layered with nickel. The nickel stays bright and refuses to etch while the carbon darkens, so the pattern separates into two clear tones instead of the uniform grey of a plain clad blade. The contrast deepens as the knife ages.

The blade

180mm and 145g. Light for the length and ground thin, so it falls through onion and herbs rather than pushing them aside. The low flat tip means the point is where you can see it, which is most of the reason a bunka feels precise.

The handle

Honduran rosewood burl with a horn ferrule. Burl is the figured wood from a growth in the trunk, so the grain swirls rather than runs, and no two blanks are alike. Honduran rosewood is dense, oily and dark, takes a deep polish, and darkens alongside the blade.

Every handle is different. The one in the photographs is the one you receive.

Specifications

Type Bunka
Blade length 180mm (7.1")
Core steel 52100 high-carbon
Cladding SK5 carbon steel, nickel
Handle Honduran rosewood burl, horn ferrule
Weight 145g
Construction Made by hand, one at a time

Care

Core and cladding are both carbon steel, so the whole blade is reactive and will darken with use. The grey patina that forms is normal, protects the steel, and on this knife is part of the design.

Wipe the blade down as you work, especially after onion, tomato or citrus, and dry it fully before it goes away. Never leave it wet. Hand wash only, never the dishwasher. Keep it off bone and frozen product, and never twist or pry. Maintain the edge on a whetstone. A spot of red rust lifts off with a rust eraser and is not damage.

If you want a knife you can leave on the sink, take one of our stainless knives instead. This one rewards attention.

Afficher tous les détails