Noseto
Noseto Buto Honing Steel 250mm, Oval, Ebony Handle
Noseto Buto Honing Steel 250mm, Oval, Ebony Handle
Impossible de charger la disponibilité du service de retrait
Buto Honing Steel 250mm
A 250mm oval honing steel with a full-tang stainless rod and an ebony handle. Built to live on the bench rather than in a drawer.
What a honing steel does
Worth being clear, because the names get used loosely. A honing steel does not sharpen. What it does is straighten an edge that has rolled over with use, which is what makes a knife feel blunt long before it actually is. A few passes before service and the edge stands back up and bites again.
When a knife stops responding to that, it is no longer rolled, it is worn, and it needs a stone.
Why oval
A round rod meets your edge along a single line, so you need more passes and you tend to wear a groove into one part of the rod. The oval face puts several times more contact under the blade at once, which means fewer strokes, more even contact along the edge, and a rod that stays usable instead of channelling. It is why professional kitchens moved away from round steels.
Why 250mm
Your rod should be longer than your blade, so that the edge travels heel to tip in one unbroken pass. At 250mm this covers everything up to a 210mm chef knife or santoku comfortably. If your main knife is a 240mm gyuto or longer, take a 300mm rod instead, because breaking the stroke halfway is how people round their edges off.
The build
Most honing steels are a rod pressed into moulded plastic. This one is full tang, meaning the steel runs the whole length of the handle, with ebony scales over it. Ebony is one of the densest timbers used in cutlery, so it is heavy in the hand, stable around water, and it ages rather than wears out. The result is balanced instead of rod-heavy, and it is a tool you will be happy leaving out on the bench.
What it suits
Best on Western and softer stainless knives, which roll rather than chip and respond to honing immediately.
Go carefully with hardened Japanese knives at 60 HRC and above. A thin hard edge does not roll in the same way, and heavy pressure on any steel can micro-chip it. Light passes only, or use a whetstone instead.
Specifications
| Type | Honing steel |
| Rod length | 250mm |
| Cross-section | Oval |
| Rod material | Stainless steel |
| Construction | Full tang |
| Handle | Ebony |
How to use it
Hold the rod tip-down on the bench or out in front of you, set the blade at roughly 15 to 20 degrees, and draw the edge from heel to tip in one smooth pass. Light pressure. Three or four strokes a side is plenty. If it needs more than that, the knife wants sharpening, not honing.
Care
Wipe the rod down after use and dry it. Do not soak the handle or put it in the dishwasher. Ebony is dense but it is still timber, and standing water is the one thing that will spoil it. A little mineral oil once or twice a year keeps the colour deep.
Partager
